casino siteleri
Computers and TechnologySEOServices

How to complete the TS3122 setup?

If you have a Canon IJ TS3122 printer and you are looking forward to completing its setup, then this guide can help you. Here, we are going to share the simple step by step instructions that can help you with TS3122 setup on your device. If we talk about the wireless connection, then there are certain access points that sometimes referred to the hub’s pr router which displays the automatic button labeled as ‘WiFi Protected setup (WPS).


The WPS connection is the only way that allows devices like the Canon Pixma printer to gets connected to the network without requiring any password and print the documents wirelessly. This is one of the quick and easy methods to connect the printer wirelessly.

So, the access point is having the WPS button, you just need to choose the ‘WPS Connection’ method below for the instructions to complete the setup using the WPS method. Before you proceed next, it is very important for you to know that if your access point doe not support the WPS connection method, then you can go for the ‘Standard Connection Method’ to connect the printer and print the documents.

Complete TS3122 setup with WPS Method: Guidelines To Follow:-

Before we proceed next, there are certain terms and conditions that your device must meet in order to use the WPS connection method.

It is important for you to check and make sure that the access point is having the Physical Push button available.

Check your device’s user guide and get the proper details to run it correctly.

In case, the WPS Push button is not available, you need to follow the Standard Connection Method instructions to complete the process.

Your Network must be following the WiFi Protected Access -WPA or WPA 2 protocol. Most of the WPS enabled access points to use this protocol.

Steps to follow are:

Steps 1

Check and make sure that you have turned on the Canon printer.

Press and hold the ‘WiFi’ button present at the top of your printer until you see the alarm light flashes once.

Step 2

Check and make sure that the light present next to the button starts to flash blue and then go to the ‘Access point’ and hit the ‘WPS’ button within two minutes.

To know the exact details to start WPS on Access Point, you can refer to the user manual and follow the given instructions.

The WiFi light ‘Blue’ on your Canon printer will continue to flash while searching, and the WiFi lamp and the power light will start to blink when connected to the access point.

Once your printer is able to establish a successful wireless connection to your network, then the WiFi lamp and power button will stop flashing and remain lit.

Confirm the Network Settings

To make sure that your printer is connected to the WiFi network successfully, you need to print the network settings of the printer, if you like to:

Check and make sure that your printer is turned on.

After that, you need to insert the A4 size sheet or Letter-sized plain paper.

Press and Hold the ‘Cancel/Resume’ button until you see the Alarm light starts to flash the 15 times and after the release the button.

The network information page will be printed.

Now, you can proceed further to install the Printer software and drivers. Visit TS3122 setup website to download the correct printer drivers and software for your device. You can also use the installation CD you got with the device, but if you want to install the latest drivers, prefer to visit the website and then download the drivers.

We hope that these simple steps will help you to complete the Canon IJ Setup for the wireless printing experience.If you still have a doubt, do not hesitate to contact the Canon experts and take professional advice to get the task done.
For more informative articles keep visiting Emu Article.

Related Articles

Leave a Reply

Your email address will not be published. Required fields are marked *

Back to top button